How to Install a Carpet

Carpet installationCarpet floor installation is a task that many people don’t like. It is tiring and takes a toll on your knees and back. Sometimes if you don’t do it right, you may end up with an ill-fitted carpet that rolls up on the edges. However, if you are a DIY enthusiast or want to save on the carpet installation cost, we’ve got your back. We have put up a step-by-step guide on how to install a carpet like a professional.

Carpet Installation (Step-by-step)

Step 1: Gather your carpet installation tools

For a good carpet and satisfying job, in the end, you will need the right carpet flooring installation tools to make your work easier and perfect.

  • Knee pads and kickers will come in handy for your knees since you will spend a considerable amount of time on all four limbs. 
  • Other essential tools include tackless strips, chalk lines, and duct tape.
  • A utility knife will come in handy for efficient measurement and cutting the required sizes and shapes.

Step 2: Prepare the room

prepare the room

The floor which needs to be carpeted should be even to get the best and expected results at the end. If you are removing an old carpet, scrape away or use sandpaper to remove any residue. If you have a subfloor made of wood, make sure you vacuum clean it to remove all the dirt.

Step 3: Install Tackless Strips

Install the tackless strips around the whole floor of your room. This helps in holding the new carpet firm. The recommended measurement is an inch from the wall, and you should install it with the tacks facing the wall while the strips hold tightly against each other.

step 4: Time for the underlay

This layer helps to provide comfort underfoot. It is the glue that binds the carpet and the subfloor. Measure the underlay according to the perimeter of your room and cut it accordingly. Use tapes and glues sufficiently to hold the underlayment tightly on the subfloor.

step 5: carpet installation

For installation purposes, you will require several carpet strips. Ensure that you leave at least six inches at the edges of the carpet that will help during trimming. Lay the strips so that they overlap and ensure that you push them up to the wall. Use a chalk line to mark the edges, which require trimming. Trim the edges with a utility knife.

step 6: Stretch the carpet

This helps to remove lumps from your carpet. You can use a carpet stretcher if you have a large room for impressive results. Otherwise, you can use your knee kickers and knee pads. From any side of the room, put the toothed end of your knee kickers three inches from the wall. Proceed to work on the carpet using knee pads all over the room until the rug is firmly in place and inseparable from the tacks underneath it. With this, you will have a seamless new carpet on your floor.

If you are tight on cash or just a hands-on individual, this serves as a practical DIY carpet installation guide. However, if you need commercial carpet installation services, feel free to contact our experts.

Carpet Installation FAQs

Q: How much does commercial carpet installation cost?

A: Professional carpet installation prices vary depending on the type of carpet, the amount of labor required, and any special requests or requirements. Generally speaking, you can expect to pay anywhere from $0.50 to $12 per square foot for a new carpet installation.

Q: Do I need to remove the old carpet before installing the new one?

A: Not necessarily, but it is recommended to have a smooth surface to install the new carpet.

Q: What is the best way to cut a carpet?

A: A utility knife is typically the best tool for accurately cutting carpets to size.

Q: How do I stretch a carpet after installation?

A: You can use a carpet stretcher for large rooms or knee kickers and knee pads for small projects. Start from any side of the room and work your way around until the carpet is firmly in place.